Tim's Web Quiz  
  Polls - Freshwater  
  Polls - Saltwater  


Go Back   Tropical Fish Forum . Net > General Aquarium Care > Water Quality and Algae

Water Quality and Algae Questions and comments about water quality.

Thread Tools Search this Thread Display Modes
Old ,
Bernie Bernie is offline
Super Moderator
Join Date: Aug 2006
Posts: 1,756
Lightbulb Info: On Cycling A New Tank


There are 2 ways to Cycle a new tank, either with fish, using their waste products to help create ammonia or without fish (which is called Fishless cycling). You must always cycle a new tank!

First set the tank up and let it run for atleast a week to allow the water to age and regulate the temperature.

What is cycling ?:

It’s a little complicated, but it’s very important to know when you own an aquarium. With a new tank/filter, you do not have enough beneficial bacteria to remove ammonia from the water, so if you aren't careful your fish could die. Cycling a tank is basically breeding a bigger colony of beneficial bacteria to convert the amount of waste your fish produces and any decaying food. There are two types: one converts ammonia to nitrite, and the other converts nitrite to nitrate. Buy a test kit to monitor the levels of these three to see how far along your cycle is, and to make sure they don't reach dangerous levels for your fish along the way. While the tank cycles, you should see a spike of ammonia and it will go down, then a spike of nitrite and it will go down, then nitrate will start to increase. Do not rinse the gravel or anything in the filter in tap water or the chlorine will kill the beneficial bacteria.

The Cycling process has 3 phases:

1st Phase:

The cycle starts as soon as there are fish in the tank or you start feeding the tank (if using fishless cycling). The waste products, & any uneaten food, break down into either ionized or unionized ammonia, which usually starts to form around the 3rd day after putting fish in the tank. The ionized form, Ammonium (NH4), can be present in a pH below 7, and is not usually harmful to fish. The unionized form of ammonia (NH3), exists in a pH of 7 or above, and this ammonia is highly toxic to fish & any amount can be dangerous, but if levels reach 2 ppm, the fish start to stress & will suffer. P.W. changes are the best way to stop high levels of ammonia forming.

You usually need to test for ammonia from the 3rd dy. & everyday from then on until you see it start to drop & then you continue testing every 2nd dy. until it remains at 0.

2nd Phase:

This is where the ammonia starts being eliminated by the “Nitrosomonas” bacteria, this process is what produces the nitrite, which is also highly toxic to fish. Nitrite levels of 1 ppm can be very harmful to some fish.

Nitrite usually appears at the end of the first week after adding fish, (but can take longer to start), which is when you should start testing for nitrite, & keep testing every 2nd dy until it reaches 0.

Again p.w.changes will help keep nitrite levels down.

3rd Phase:

This final phase of cycling (which can happen very suddenly), is when bacteria called "Nitrobacter" bacteria change the nitrites into nitrates, which in moderate levels is not too harmful to fish, an acceptable level is 5 ppm, but can be as high as 30 ppm before it starts harming fish (but it isn't a good idea to leave it that high if it does get to that level). In a cycled/established tank you should normally get a nitrate reading that is between 5-10 ppm.

P.W.changes will keep levels down if they get too high, & once the tank has been established you only need to check the nitrates every 3 months or so.

Once you have a constant reading of ammonia = 0 nitrite = 0 nitrate = 5 ppm (but nitrate may be a bit less/more) for a couple of dys, you're tank has finished cycling.

The different ways to cycle a tank:

Cycling with Fish:

When setting up an aquarium, buy some hardy fish (definitely not neons) to get the cycle started. These fish are often called "Starter Fish" & the purpose of these fish is to provide ammonia through respiration, fish waste, and decaying food. The ammonia allows the first set of nitrifying bacteria to colonize and to initiate the cycling of the tank.

During this time of cycling, ammonia and later nitrites will spike up to dangerous levels for the fish, so after 3 dys of adding the fish, you need to monitor these levels daily & do partial water changes every 2 to 3 dys (it may be needed every dy if levels get too high, as well as cutting back on feeding or stop feeding for a day or so). Some fish may not survive the cycling process, so it is best to be prepared for some losses.

The cycle is complete as soon as ammonia and nitrite levels are no longer measurable and you have a nitrate reading as mentioned earlier. This form of cycling takes anywhere from 4-8 wks.

Fishless Cycling:

All you need to do is set up the tank with at least gravel, a filter and water and preferably a heater to maintain a temperature Of around 80*F as bacteria grow faster in higher temps. (but it is not absolutely necessary). Add cheap fish flakes daily and siphon every two weeks just as if you had fish in the tank & keep monitoring the levels of ammonia, nitrite and nitrate.

Once your nitrogen cycle is fully established, do a series of water changes over a few days (still feeding) and then add your fish. This way you can add more at a time and none of the fish will be harmed from ammonia or nitrite levels, and it's much less work and stress on yourself.

Seeding the tank can speed up this process. (Seeding basically means the introduction of existing bacteria colonies into a new tank). The decaying food will provide ammonia for these colonies to settle and grow in the new tank. This method also takes 4-8 weeks.

There is also a second way to do a fishless cycle which requires a bit more effort, which is:

Using Pure Ammonia to Cycle:

Instead of using fish food for ammonia production, you can also introduce pure ammonia to the tank.

After the tank has been set up, add 5 drops of ammonia per 10 Gallons into the water on a daily basis.

Ammonia will rise to 5 ppm and higher. As soon as you can measure the nitrites, reduce the ammonia to 3 drops per day. Nitrites will rise to similar levels. Keep adding 2-3 drops until the measurements of ammonia and nitrites come out with 0 ppm. The tank has then completely cycled.

With the fishless method, when the fish are introduced into the tank there is a risk of creating by-products such as phosphates, which occurs by decaying food. The ammonia produced might not be sufficient to create enough bacteria colonies to hold the fish when they are introduced, and this will trigger another growth of bacteria with spikes in ammonia and nitrites.

These re-renewed spikes however will be much shorter and less intense compared to the initial ones experienced during the primary cycle. Consequences for the fish are minimal, making this at least fish-friendlier. This method is usually quicker taking approx. 2-3 wks, but it can vary.


The tank needs to be well oxygenated as the bacteria require oxygen.

A tank may become cloudy during cycling which is normal, it is usually caused by a bacterial bloom as the bacteria establish/colonise and usually will clear up on its own.

If using ammonia cycling:

The ammonia used should be free of any perfumes and additives, but just in case, use act.carbon to remove any traces of them after the tank has cycled.

Do not treat the water with conditioners that remove ammonia.

Water changes are only necessary if the ammonia and nitrite levels are too high, which should only occur if more than 5 drops is used per 10 Gallons of water.

After stocking your tank with fish, general maintenance of the aquarium is all that is required. The bacteria will adjust to the fish load and if you plan to add more fish the bacteria will need to adjust again.

Remember that a tank has cycled if ammonia and nitrites are back at 0 ppm. At this time you can stock the tank with fish. If no fish are introduced, the bacteria will still need to be fed.


References: Bernie, LittleHippyGirl, Algone.com, freshaquarium.about.com

Last edited by Dano : at . Reason: more information
Old ,
sandygirl sandygirl is offline
Senior Member
Join Date: Dec 2007
Location: Orillia Ont, Canada
Posts: 258
Default Re: Cycling A New Tank

I only setup my new 10 gal. tank on Sat. I put the old filter in from my 28 gal tank. added some gravel a heater. I plan on adding a bit more gravel. When I tested it today the Ammonia was 0, Nitrate 0, Nitrite 0, I have never had these readings in my 28 gal tank. Is it ready or is this just the calm before the storm. I am not adding any fish till I have the tank decorated the way I want, but is it possible for a tank to cycle this quick.
List of Chrysler transmissions

Last edited by sandygirl : at .
Old ,
fishlover's Avatar
fishlover fishlover is offline
Senior Member
Join Date: Feb 2008
Location: WI, United States
Posts: 439
Default Re: Cycling A New Tank

I have had tanks cycle right away with just using water from another tank. I did dig down and get some of the "good stuff" out of the gravel to go along with the water. I never did get an ammonia spike with my 29 gallon and so far, I haven't gotten one with my six gallon either. My readings always stayed where they should be. Weird.

If I were you, though, I would wait a bit yet just to be sure. You had such a pain with the first tank it would be a shame to go through the same thing with this tank.

"Life is not measured by the number of breaths we take, but by the number of moments that take our breath away."
Old ,
Aquaman#1's Avatar
Aquaman#1 Aquaman#1 is offline
Senior Member
Join Date: May 2007
Location: Warner Robins Georgia
Posts: 287
Default Re: Cycling A New Tank

Good article!
Old ,
Dano's Avatar
Dano Dano is offline
Senior Member
Join Date: Oct 2007
Location: Goose Creek SC USA
Posts: 1,892
Default Re: Cycling A New Tank

If there never was an ammonia reading, the cycle probally never got started. Adding bacteria without an ammonia source will not cycle a tank. The bacteria need ammonia to grow.

Last edited by Dano : at .
Old ,
Bernie Bernie is offline
Super Moderator
Join Date: Aug 2006
Posts: 1,756
Default Re: Cycling A New Tank

I agree with Dano! If you are doing the fishless cycling Sandy, are you adding fish food to the tank? the decaying food produces the ammonia needed.

In any tank when it has cycled you should always have some reading of nitrates.

Last edited by Bernie : at .
Old ,
Sharon's Avatar
Sharon Sharon is offline
Join Date: Jan 2007
Location: Newfoundland, Canada
Posts: 2,290
Default Re: Cycling A New Tank

Sandy, you CAN use household Ammonia to cycle, or to see if the tank is cycled due to using a mature filter. Add just enough Ammonia to get a reading of 5ppm(you won't need much to do this). Wait 24 hours ....if the readings return to 0, the tank is cycled. The Nitrates are probably reading 0ppm, due to having all new water.

5 gal... Robin, (Betta)
5 gal...Pete, (Betta)
5 gal...Scotty(Betta)
10 gal...Female Betta Sororiety
10 gal... Neons, Glolights and Cardinals, 1 Oto
10 gal... Ram Pair
29 gal... Mbuna Tank
29 gal... Krib Pair, Tiger Barbs, Tetras, 2 Otos
55 gal...5 Australian Rainbows, 1 Angel Fish, 1 Blue Gourami, 6 Congo Tetras, 1 Leopard Ctenopoma, 1 Clown Pleco, 1 UpsideDown Catfish,5 Otos, 1 Bronze Cory, 2 Peppered Cories,2 Panda Cories
Old ,
suppleupagus's Avatar
suppleupagus suppleupagus is offline
Senior Member
Join Date: Feb 2008
Posts: 345
Default Re: Cycling A New Tank

Thanks for posting this Bernie! GREAT article, very informative

Old ,
lLz lLz is offline
Junior Member
Join Date: May 2008
Posts: 26
Default Re: Cycling A New Tank

nice post. really easy to understand
but...whats P.W??...i'm really new to this =\
Old ,
StormySkiez's Avatar
StormySkiez StormySkiez is offline
Senior Member
Join Date: Feb 2008
Location: TN
Posts: 598
Default Re: Cycling A New Tank

PW= Partial water change . I do aprox 15% water changes weekly.
C:\Users\Kim\Pictures\Avatars & Sigs\TTF Sig1.jpg
55g - 2 green spotted puffers in brackish conditions
20g- 6 leopard danio,2 glofish danios,4 whiteskirt tetras,shrimp & neritas
10g- ramshorn & pond snails,3 neon tetras, cherry shrimp
10g- QT tank-empty
2.5- QT tank- nerita,amano,anacharis
TTF Album
TPF Gallery

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Helpful Information for beginners: What fish to buy Kathryn Stocking Tank Tips 3
Confused about reading test results Vanessa B Water Quality and Algae 16

All times are GMT. The time now is .

Powered by vBulletin Version 3.6.0
Copyright ©2000 - 2019, Jelsoft Enterprises Ltd.